Melburg Luft

Hi all, Just after an inner race for a CV joint for my Type 3. I think they are the same as a bug. One shat itself while pressing the joint from the axle. I'm located in Launceston, TAS, so local pickup preferred, but if you want to put one in a box and send me one, then that's great too. Cheers, Paul

Hi, I'm after a good replacement section for my late Type 3 project pan. I need a passenger side rear quarter floor pan section, from the seat mount to the divide under the rear seat. The only rust in my pan was in this section. Happy for a good used section cut from a wreck, along as it has no hole...

Hi everyone, I know it's a long shot, but before I put in another order to the US for Dell parts does anyone have laying around a CB Performance Dellorto linkage. If you don't know what I mean it's the double threaded shaft with a swivel linkage at each end. I busted one trying to undo an end. It ha...

I'm after a pair (for one carbie) of auxillary venturis for a 40mm Dellorto DRLA carbie.

Used, but good condition is fine. The pair I have have been slightly melted due to a stuck butterfly.

Any help appreciated.

Cheers,

Paul

Nice. Thanks Barny.

Hi all, I'm looking for a VDO oil temp guage in the style below. Ideally it would be a 300F gauge as that's the sender I have, but I'll look at anything. http://i147.photobucket.com/albums/r315/vandenbergp/015.jpg If anyone has any other VDO gauges in this style (CHT, vacuum, fuel etc) I also be int...