Page 1 of 1
wanted 1200 (40hp) inlet manifold
Posted: Mon Jul 11, 2011 10:45 pm
by jnr356
madmaddy wrote:Can someone tell me if you can buy a new replacement manifold, as the one I have is cracked.
The part number is hard to read I think it is 113 129 701.
1962 1200cc beetle
thanks
Jenny
Posted: Mon Jul 11, 2011 10:53 pm
by MaineBugs
Might have one in the shed i can check tomorrow night. Thats if a second hand one is okay
Posted: Mon Jul 11, 2011 10:58 pm
by madmaddy
yes a second hand should be fine.
Thanks
Jenny
Posted: Mon Jul 11, 2011 10:59 pm
by MaineBugs
Will have a gander tomorrow arv
Posted: Tue Jul 12, 2011 7:51 pm
by GASBNR
I have a 40hp inlet I'm not using. Might be a little blocked.
Also 2 other 40hp & 1300 motors in need of removal.
OL
Posted: Tue Jul 12, 2011 8:08 pm
by snEEk
OL's onto it... i think the 1300 ones are different though
i looked for a while trying to find one for the 61, i reckon most you will find second hand are blocked through the heat riser tubes. to check them put ya mouth on the end and try and blow through it... in the end i ended up bashing the one i had between a nice lump of steel with a hammer all the way along the manifold
if done gently enough you can bang loose all the corrosion inside and shake out the flakes to unblock them, but it takes a while.
makes a HUGE difference
Posted: Tue Jul 12, 2011 8:41 pm
by madmaddy
The one that you have will it fit a 1200cc 62.
Posted: Tue Jul 12, 2011 8:47 pm
by madmaddy
If its blocked maybe I can drill it out and weld up drill holes after clearing the tubes. Has anyone done this before.
Posted: Tue Jul 12, 2011 8:52 pm
by NUG637
If you got an old clutch cable or steel cable of the like, put that in the chuck of a drill and feed it in the heat riser giving it all you got
Posted: Tue Jul 12, 2011 9:00 pm
by snEEk
madmaddy wrote:If its blocked maybe I can drill it out and weld up drill holes after clearing the tubes. Has anyone done this before.
the bash theory worked well, but ya need a good piece of steel to rest it on while you hit it... the shockwave going through the tube frees up all the crap then shake it out
nugs drill idea sounds like its worth a go too
Posted: Tue Jul 12, 2011 9:21 pm
by martinigreenbus
Need a scrappy Ol?
Posted: Tue Jul 12, 2011 11:17 pm
by MaineBugs
Sorry i only have 1300 and 1500 i had a 36er one but used it to smash up a paddock bomb looks more like a set of extractors now lol
Posted: Wed Jul 13, 2011 8:23 pm
by jeeves
Jenny, do you still need a manifold?
Pretty sure I've got one in the shed, and We're moving house in 2 weeks, so I have to start re-settling some of my parts.
I'll go check.
Posted: Wed Jul 13, 2011 9:21 pm
by jeeves
Yep, same part number.
It's yours if you need it.