Page 1 of 1
WTD: Type 3 Pan-head for a Jig + Type 3 IRS subframe
Posted: Tue Aug 02, 2011 6:29 pm
by muz
Hi guys,
Just putting the feelers out to see if anybody has a rusty type 3 pan laying about that they would be able to cut the pan head off of?
Wanting to use it to save the time of making a jig so i can fab up a new front beam.
Cheers,
Muz
Posted: Tue Aug 02, 2011 6:39 pm
by hertz
Didnt the notch have a narrowed beam Muz?
Posted: Tue Aug 02, 2011 6:50 pm
by muz
yeah it does, i'll probably roll that one but there's a few things i want to clean up on it and remove. I want to remove the necessity to run spacers between the mounts and the pan head and also want to cut off the bottom mount for a little extra ground clearance.
Posted: Tue Aug 23, 2011 8:32 pm
by muz
Still on the hunt!
Posted: Wed Aug 24, 2011 1:38 am
by Phat Bug
I know of one, I'll put the feelers out.
Posted: Wed Aug 24, 2011 6:21 am
by muz
Thanks Rhett! Appreciate it
Posted: Sat Jul 14, 2012 6:30 pm
by muz
Bump!
I'll even take a whole late model type 3 IRS pan if the price is right
Posted: Sat Jul 14, 2012 9:41 pm
by type3disease
Bigdolpha is wrecking a fastback...!
Pan sections are getting cut out I believe but rear and pan head should be cool...!
Posted: Sun Jul 15, 2012 7:35 am
by muz
cheers Ben
do you know if it's IRS?
Posted: Sun Jul 15, 2012 10:47 am
by nectar_f
muz wrote:cheers Ben
do you know if it's IRS?
hey muz, itshould be, as from 1969 they went to irs on type 3s.
Posted: Sun Jul 15, 2012 11:06 am
by type3disease
Posted: Sun Jul 15, 2012 1:17 pm
by muz
thanks for the help guys, I'm talking to bigdolpha about it now.
Posted: Sun Jul 15, 2012 3:32 pm
by type3disease
