Melburg Luft

Am thinking of running a 2 inch link pin beam on my oval. Anyone got a complete beam, with tie-rods, arms etc they want to part with? Must have shock towers and be more or less ready to bolt in. PM me if you have something suitable.

I'm located in Eltham but am prepared to pick up in the greater Melb region.

Thanks in advance
Cam

down under beams may be able to help you out

Also DAS Resto's supply the Airkewled beams which are a bolt in package

Bump TTT. Anyone have one they're looking to offload?
Cam

I can build you one or are you wanting one cheap?

captainvw wrote:I can build you one or are you wanting one cheap?

Thanks for that, I was hoping to pick one up that someone wanted to offload if they we upgrading to a 4+ inch beam rather than go a custom build route.

Cam

Nevada51 wrote:

captainvw wrote:I can build you one or are you wanting one cheap?

Thanks for that, I was hoping to pick one up that someone wanted to offload if they we upgrading to a 4+ inch beam rather than go a custom build route.

Cam

I have a stock beam I can put some adj and end plates on to keep costs down if you get stuck

Nevada51 wrote:

captainvw wrote:I can build you one or are you wanting one cheap?

Thanks for that, I was hoping to pick one up that someone wanted to offload if they we upgrading to a 4+ inch beam rather than go a custom build route.

Cam

I have a stock beam I can put some adj and end plates on to keep costs down if you get stuck

i have a 4 inch beam with flat plate style shock towers. adjusters are set up for use with dropped spindles, which pushes you back out to 2 inches.

let me know if you are interested.

*did* wrote:i have a 4 inch beam with flat plate style shock towers. adjusters are set up for use with dropped spindles, which pushes you back out to 2 inches.

let me know if you are interested.

What spindles are you running that push you out an 1" each side ?

I think CB performance do.

yeah from memory my CB's roughly did but not quite a full 2...

yeah ok less than 2 inches but close enough. i suppose i was running wider offset wheels too.

I'm currently running a 4.5" narrowed beam with CB spindles. The spindles push it out around 0.5" on either side.

I am looking to go back to a more stock look, but still want to keep the option of swapping the 4.5" beam back in. I may end up putting the stock beam back in but I really wanted to tuck the wheels a little more if it wasn't going to be an overly expensive proposition.

stock is the new narrow.

benham1 wrote:stock is for people with pussies between there legs

yeah i agree

I can't describe what I just found on the inter web in search of a visual reply to that comment, and I certainly can't post it, but I can tell you there's a famous gay male porn star who rolls stock...

Dude leave it as is it looks sick
Love seeing it rolling round town
Puts a smile on my face