Melburg Luft

hey guys, im in desperate need of a few 0.38 flywheel shims so i can finish the flywheel and clutch on my 36 hp build....

please, any help would be muchly appreciated.

Nugget.

hi nug, you might be struggling there. the '58 manual only lists shims up to 0.36 and the 1200 parts manual to 0.34mm. (0.38 is available for 1300's but that is of no use to you)

i have a 0.30 if that is of any help.

sorry i haven't posted the tin yet, having a really broke week.

The manual I got says they came up to 0.38 mm. I have found 2 in the spare 36ers we have but am in desperate need on one more... If I have to I'll buy them off the samba but I was hoping for something more local.

No stress about the tin mate... Simon hooked me up with a rear (over flywheel) and deon might have found me a front

there are no 0.38's

i have a wad here ,tell me what you want and i'll get 'em off to ya

you'll have to do some more mixing/matching to come up with the right number

I Must have just out of wack 0.36mm ones then? If thats the case I should be able to make do...

Sorry about the confusion guys... The book says it can get them up to 0.38, tho It might be referring to 1600's?

Thanks for the offerings and to a few who went and measured what they had

My bad...

LT has them at 38...
http://www.thesamba.com/vw/classifieds/ ... id=1112859

That other motor is sitting here waiting for you to just flick the flywheel off.

Flywheel is off! (I found the you beaut CIP 36mm nut remover dodad)
I'll get the shims off tomorrow, but I have lent my calipers to a mate so I can't measure them.