Page 1 of 1
WANTED NEW TYPE 4 CAM
Posted: Sat Mar 28, 2009 1:23 am
by dyno
All, looking for a mild grind type 4 cam I can still use with standard carbs for reasonable $. Not interested in used or standard and looking for something around 270 degrees duration and 0.400 inch lift @ the cam(advertised). Anyone out there with some old stock kicking about(eagle, CB, Scat)? Would also be interested in new graded(-2 and -3) bolt on cam gears for the same cam too.
Regards, Andrew.
Adelaide , 0409360075.
Posted: Sat Mar 28, 2009 7:09 am
by jnr356
could try clive cams
in mitcham
victoria
sorry haven't got there no. handy
Posted: Thu May 07, 2009 11:45 pm
by dyno
thanks anyway, ordered one from the states, the VW traders in Australia were far too steep with the prices.
Posted: Sat May 09, 2009 8:58 pm
by Edwin
just out of interest where did you order it from.
i will be looking to do an engine build for my 914 later this year and would be interested in knowing you thoughts on this one when you get it.
cheers
edwin
Posted: Sat Jun 27, 2009 2:25 am
by Rick_Eberle
I have a Web 86 in my 914 1.7, and I love it. A nice flat torque curve, and with ITB's a nice smooth idle. Pulls like a train right up to the rev limiter at 6250rpm.