Page 1 of 1
type 3 bits needed
Posted: Wed Aug 05, 2009 6:20 pm
by nectar_f
Hey all, Just wondering if anyone is wrecking a late type 3, or has these parts I require.
Disc spindles for type 3. They would need to be the 68-early 71 ones, with the caliper bolt spacing the same as Bug calipers.
Thanks heaps, Nectar
Posted: Wed Aug 05, 2009 7:53 pm
by Water Boy
There is a late Type 3 Square at Pick a Part Kilsyth.
Re: type 3 bits needed
Posted: Wed Aug 05, 2009 9:55 pm
by rossko
nectar_f wrote:Hey all, Just wondering if anyone is wrecking a late type 3, or has these parts I require.
Disc spindles for type 3. They would need to be the 68-early 71 ones, with the caliper bolt spacing the same as Bug calipers.
Thanks heaps, Nectar
I'm thinking I might have a disc beam, type III,
how soon do you need it?
its in storage is why the uncertainty.
actually, thinking about it I do have two disc spindles,
not sure of year.
Posted: Wed Aug 05, 2009 10:49 pm
by nectar_f
wasser Boy wrote:There is a late Type 3 Square at Pick a Part Kilsyth.
A bit far at the moment to get out there, to pull them off, but I may go out there in a few weeks if nothing comes up...
Thanks mate,
Re: type 3 bits needed
Posted: Wed Aug 05, 2009 10:50 pm
by nectar_f
rossko wrote:nectar_f wrote:Hey all, Just wondering if anyone is wrecking a late type 3, or has these parts I require.
Disc spindles for type 3. They would need to be the 68-early 71 ones, with the caliper bolt spacing the same as Bug calipers.
Thanks heaps, Nectar
I'm thinking I might have a disc beam, type III,
how soon do you need it?
its in storage is why the uncertainty.
actually, thinking about it I do have two disc spindles,
not sure of year.
Mate, its not Urgent, but I would like them soonish (next couple of weeks!)
Let me know...
Thanks again, Nectar