36HP Crankshaft Pulley

Nevada51 · Post by **Nevada51** » Sat Mar 30, 2013 2:35 pm

I don't believe my 36HP crankshaft pulley is supposed to be in two pieces as shown in the pic, so I am in urgent need of a replacement. Anyone got one they want to part with??

PM me.
Cheers
Cam

Jase · Post by **Jase** » Sat Mar 30, 2013 3:30 pm

On my phone so hard to see

Is that an early thin lip?

Nevada51 · Post by **Nevada51** » Sat Mar 30, 2013 4:27 pm

Jase, not sure what the difference is. Here's a close up if that helps any.

Cam

Leroy · Post by **Leroy** » Sat Mar 30, 2013 9:25 pm

I've got one here if you get stuck mate

Tonz Magonz · Post by **Tonz Magonz** » Sat Mar 30, 2013 11:47 pm

Can't it be rewelded..?

Nevada51 · Post by **Nevada51** » Sun Mar 31, 2013 7:36 am

Tonz Magonz wrote:Can't it be rewelded..?

Probably can be, but I don't have a welder, and its my daily driver so need it sorted ASAP

Leroy wrote:I've got one here if you get stuck mate

Cheers Leroy, I may have sourced one locally - will know later this evening. If not, I may take you up on yours.

Cheers
Cam

Nevada51 · Post by **Nevada51** » Mon Apr 01, 2013 1:07 pm

After sourcing one from Ol (thanks mate), it turns out that, despite looking extremely similar, it wasn't quite the right size. My pulley is around 182mm in diameter, and the replacement one I have is 175mm in diameter. Lip looks exactly the same.

Not sure what is the correct size...but my fan belt won't fit the replacement.

Cam