WANTED: Rear Torsion Housing/pre 67 pan to cut up

muz · Post by **muz** » Fri Dec 26, 2008 7:06 pm

Chasing a rear torsion housing out of a pre 67 floor pan and also some 'short axle' axle tubes.

Will buy a complete rolling pan if i have too!

Call Murray on 0415 392 754 or PM, or email: mpigdon@aapt.net.au

Cheers,

Muz

muz · Post by **muz** » Fri Dec 26, 2008 7:09 pm

need this shit ASAP so i can get things 'rolling' in the new year

captainvw · Post by **captainvw** » Fri Dec 26, 2008 8:30 pm

You Muz are a bad man !

muz · Post by **muz** » Fri Dec 26, 2008 8:48 pm

muz · Post by **muz** » Sat Dec 27, 2008 4:27 pm

Bump!

surely one of you hoarders out there have an old crappy pan you need out of the way... why not let me buy it off of you and chop it up

MaineBugs · Post by **MaineBugs** » Sat Dec 27, 2008 8:01 pm

my brother just picked up a complete pan tan from a 64 today i can ask and let you know if you like. pm me

muz · Post by **muz** » Sat Dec 27, 2008 8:09 pm

PM sent MaineBugs

muz · Post by **muz** » Wed Dec 31, 2008 6:08 am

anybody?

OMR_007 · Post by **OMR_007** » Wed Dec 31, 2008 8:39 am

Got a spare here in QLD, but I guess thats no help to you

muz · Post by **muz** » Thu Jan 01, 2009 12:58 pm

OMR_007 wrote:Got a spare here in QLD, but I guess thats no help to you

spare pan or spare torsion housing?

OMR_007 · Post by **OMR_007** » Thu Jan 01, 2009 1:07 pm

A spare pan (very rusty tunnel) that has a good torsion housing on it

EDIT: Just made plans to pick up another rusty one tomorrow, so will have 2 pre '67 pans

muz · Post by **muz** » Thu Jan 01, 2009 2:55 pm

damn! and i can't get one rusty pan down here

muz · Post by **muz** » Sun Jan 04, 2009 8:07 pm

My angle grinder is itchin to do some cutting!

any leads at all people?