Page 1 of 1
WANTED: Rear Torsion Housing/pre 67 pan to cut up
Posted: Fri Dec 26, 2008 7:06 pm
by muz
Chasing a rear torsion housing out of a pre 67 floor pan and also some 'short axle' axle tubes.
Will buy a complete rolling pan if i have too!
Call Murray on 0415 392 754 or PM, or email:
mpigdon@aapt.net.au
Cheers,
Muz
Posted: Fri Dec 26, 2008 7:09 pm
by muz
need this shit ASAP so i can get things 'rolling' in the new year
Posted: Fri Dec 26, 2008 8:30 pm
by captainvw
You Muz are a bad man !
Posted: Fri Dec 26, 2008 8:48 pm
by muz
Posted: Sat Dec 27, 2008 4:27 pm
by muz
Bump!
surely one of you hoarders out there have an old crappy pan you need out of the way... why not let me buy it off of you and chop it up
Posted: Sat Dec 27, 2008 8:01 pm
by MaineBugs
my brother just picked up a complete pan tan from a 64 today i can ask and let you know if you like. pm me
Posted: Sat Dec 27, 2008 8:09 pm
by muz
PM sent MaineBugs
Posted: Wed Dec 31, 2008 6:08 am
by muz
anybody?
Posted: Wed Dec 31, 2008 8:39 am
by OMR_007
Got a spare here in QLD, but I guess thats no help to you
Posted: Thu Jan 01, 2009 12:58 pm
by muz
OMR_007 wrote:Got a spare here in QLD, but I guess thats no help to you
spare pan or spare torsion housing?
Posted: Thu Jan 01, 2009 1:07 pm
by OMR_007
A spare pan (very rusty tunnel) that has a good torsion housing on it
EDIT: Just made plans to pick up another rusty one tomorrow, so will have 2 pre '67 pans
Posted: Thu Jan 01, 2009 2:55 pm
by muz
damn! and i can't get one rusty pan down here
Posted: Sun Jan 04, 2009 8:07 pm
by muz
My angle grinder is itchin to do some cutting!
any leads at all people?
